CONFAST Carbide Hammer Bit Now Available

Straight shank bits, or Hammer bits, are carbide-tipped bits used for drilling holes in concrete, brick or block base material. The tip of the bit is made out of carbide.

These carbide-tipped bits are used in mechanical hammer drills.

The straight shank bits are attached to the hammer drills via a chuck. The straight-shanked bit is used in a Jacobs style chuck (a chuck in which a key is used).

Confast’s straight shank bits are American made of premium quality steel and carbide. Straight shank bits are available in diameters from 1/8" to 1-1/2" and up to 24" in length.

Products Features

TRICARB® CARBIDE: Guarantees longer bit life and speedier penetration due to increased chiseling action

THUNDERTWIST® FLUTE DESIGN: Faster dust removal allows faster drilling

COPPER BRAZING: Increased bonding of carbide to steel results in improved reliability

VACUUM HEAT TREATED: Provides superior strength under the toughest conditions

SHANK 6 -sided hex

LENGTH MEASUREMENT End to End

DIAMETER 1/8"

LENGTH: 3"

Concrete Fastening Systems, Inc. 1231 E. 26th St Cleveland, OH 44114 United States of America
1-216-357-7431

Press
Nanette Gregory
nanette@nsgconsultinginc.com.

Concrete Fastening Systems, Inc. has been selling concrete fasteners for over 35 years from a fully stocked warehouse in Cleveland, Ohio. Free, same-day shipping in every length and diameter is available by ordering at www.confast.com, followed by product delivery within 1-3 days.

This release was published on openPR.