Magna Chek, Inc. Receives Nadcap Accreditation.

Nadcap recognizes Magna Chek, Inc. for its commitment to continual improvement in aerospace quality. Magna Chek, Inc. announces that it has received Nadcap accreditation for Aerospace/Defense material testing.

“This is an exciting time for Magna Chek, Inc. beginning this new chapter in inspection. It will not only diversify our key client base, but also enable Magna Chek, Inc. to tap into a specialized market that is very critical” says Scott Bucholz of Magna Chek, Inc.

Magna Chek, Inc. received Nadcap accreditation for demonstrating their ongoing commitment to quality by satisfying customer requirements and industry specifications.

“Achieving Nadcap accreditation is not easy: it is one of the ways in which the aerospace industry identifies those who excel at manufacturing quality product through superior special processes. Companies such as Magna Chek, Inc. work hard to obtain this status and they should be justifiably proud of it,” said Joe Pinto, Vice President and Chief Operating Officer at the Performance Review Institute. “PRI is proud to support continual improvement in the aerospace industry by helping companies such as Magna Chek, Inc. be successful and we look forward to continuing to assist the industry moving forward.”

When non-destructive testing methods are used, all the anomalies are found. And most importantly, you get all your pieces back. After the inspection, you will know the limitations of each piece. Repairs and changes (if necessary) can be made with the knowledge of exactly where the problems lie. Whether you have one part or one million, whether they are twelve inches long or twelve feet, we can explore surface and sub-surface discontinuities while delivering accurate results each time.

Non-destructive testing encompasses a variety of technologies. Each of these technologies is designed to ferret out surface and/or sub-surface discontinuities. However, not all NDT technologies are equally good at finding a specific defect. A number of factors comes into play: material of the part, geometry of the part, etc. Designers need to consider what type of defects are likely to occur in the manufacturing process and determine what inspection methods are best suited to discover them. This information should then be incorporated into the spec. Not sure what method is best for your part? Call us and we'll help you to determine the best testing technology for your particular part.

For on site testing of containment vessels and other structures, Magna Chek has a fully equipped mobile inspection unit that can be brought directly to the job site. We can also design, build and install a non-destructive testing operation in your facility that's tailor made for your product(s). We will train your personnel to run the operation or run it for you. You'll save time and money!

Magna Chek, Inc.
32701 Edward Ave
Madison Heights, MI 48071
Contact: Scott Bucholz

This release was published on openPR.